• Reading 0.001 mm
• with dial gauge 1mm
• fixed steel measuring bolt
• movable measuring bolt made of carbide
• incl. case

Internal precision measuring device for measuring bores for: dimensional accuracy, ovality, conicity.
Self-centering with interchangeable probes.
Supplied with dial gauge.

Measuring range (mm)	Missions	discs	Extensions	Measuring depth
18 - 35 mm	9	1	-	150 mm
35 - 50 mm	4	4	-	150 mm
50 - 160 mm	12	4	1	150 mm
160 - 250 mm	5	5	1	400 mm
250 - 450 mm	4	5	2	400 mm

Measuring with the internal precision measuring device

Construction
The internal precision gauge is a comparative measuring device for measuring internal dimensions, usually bore diameters. It consists of a measuring head and a shaft, at the end of which the dial indicator is clamped.
A fixed measuring stop is mounted on one side of the measuring head. This can be replaced, allowing the measuring range of the device to be adjusted. This allows for large measuring ranges to be covered. Opposite is a movable measuring pin, whose movement is transmitted to a rod in the shaft and thus to the measuring pin of the dial indicator. Depending on the model of the internal precision measuring device, the travel of the movable measuring pin is 1-3 mm.




a movable measuring bolt
b fixed measuring stop
c spring-loaded stop bridge with cradle-shaped ends
d shaft
e Redirection of the measuring bolt movement by lever


Default
The internal precision measuring device allows measurements with very low error margins, provided the presetting and measurement are carried out correctly. Before use, the internal precision measuring device is preset as follows:
The interchangeable measuring stop that brings the length of the measuring head closest to the measurement to be measured is mounted. The dial indicator is inserted and clamped with some preload (approximately 1-2 turns).
Since the dial indicator only determines the deviation from a known measurement, a precise internal dimension must be defined using a reference gauge. This reference gauge can be, for example, an outside micrometer, a setting ring, or another setting device. The dial indicator scale is now adjusted so that the 0 on the scale aligns with the position of the pointer at the reversal point. This should be done as precisely as possible to eliminate measurement errors.


measurement
The spring-loaded centering bridge on the side of the movable bolt centers the measuring head in the bore. In the horizontal position, the measuring head must be aligned manually to find the dial indicator's reversal point: Swing the measuring device slightly back and forth until the maximum deflection of the dial indicator's pointer (reversal point) is found. This is the desired measured value.




a Adjust the measuring instrument to the reference size using the setting ring or gauge block; set the dial indicator to zero
b Insert the measuring head into the bore; determine the bore dimension at the reversal point of the pointer by swiveling the head; read the deviation


Evaluation
The measured value must now be compared with the preset reference value. If the pointer's reversal point is after 0 on the scale, the value is smaller. Therefore, the measured value is subtracted from the reference value. If the reversal point is before 0, the value is larger, and the measured value is added.
Measured quantity = comparison measure - measured value

Example:
The internal precision gauge was preset to 70 mm and a deviation of 0.02 mm was measured. The bore diameter is therefore 70 mm – 0.02 mm = 69.98 mm.